Make Canada Free Again

Carved today from two pieces of leftover tongue & groove oak flooring that I glued together. Pocket carve with a 1/8 inch 1-flute downcut bit. A 1.5 mm downcut bit was used to pocket cut the words outside of the maple leaf and to contour cut the outside of the word “Canada”.

All cuts to 1 mm depth on my Genmitsu 3018 PROVer, designed in Carbide Create. This was a prototype and if I make any more, I will probably a little deeper as I was just barely getting through the top layer of wood.

Leave a Reply

Your email address will not be published. Required fields are marked *